[TheForge] Air Hammer Main Upright and GuideHead Mount???!!!

[Mike Linn]

Use the 8" beam and weld 2" of plate between it and the upright.

The width of the beam is mainly for throat clearance.

mike

At 06:52 AM 6/10/2005, you wrote:
>Not the same.
>Resist bending.
>
>-
>Another question, similar to the last one, I can
>easily get 8" I-beam, but not 10" as called for in the
>ABANA Kinyon plans.  How about if I use the 8" and
>weld a piece of 1/2" plate, 10" wide to the front of
>the guide head mount?


            Mike Linn
      Artist Blacksmith
          McCalla, AL
        AFC Webmaster
http://afc.abana-chapter.com

______________________________________________________________________

"Many of life's failures are people who did not realize how
   close they were to success when they gave up. "
   ~ Thomas A. Edison
______________________________________________________________________