[TheForge] Clutched motor...

[Michael Horgan]

try this, 
http://allshops.org/cgi-bin/community/communityalbumdirectory.cgi?searchword=helve

It's been gone over time and again...


At 09:00 AM 1/3/2005, Roger R Degner wrote:
>Anyone know which photo album these are in
>I went to the site and found a lot of pictures to look at but not the
>one of the small hammer
>Thanks
>
>Roger R Degner
>
>
>
> >
> > Andy- the metalshapers have been using these to build small sheet
> > metal
> > helve hammers- they are perfect for that- a hammer for forming 16ga
> > looks like a minature version of an old bradley helve, made from
>welded
> > square tubing, and your motor has enough oomph for that. check out the
>
> > photo albums on www.metalshapers.org, for ideas.
> >
> >
>
>_______________________________________________
>Manage membership or unsubscribe at:
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith at hotmail.com
>password:  anvil
>___________

Michael D. Horgan , lughaid at earthlink.net
http://members.aol.com/lughaid/
posting from
  A BRAZEN FORGERY
Blacksmithing and Metalwork
Claremont, Ca.