[TheForge] Concrete forms

[GHS]

I spent way to much time yesterday looking for a source for some 
peculiar ridge cap for a customer.
I traveled via telephone and Internet the length and breadth of this 
country with short excursions across the borders.
No luck.

Normally I wouldn't bother any more, but this guy does a lot of this 
sort of thing and it would be a nice income stream.

These will be made from 26 ga. galvanized iron.
I did pound one out on a stake so it is an option. Although I doubt that 
I could get what it would  have to cost to make the project worth while.

This guy has a whole house done using the old ridge , but is ten pieces 
short. Naturally his helper did not *start *installing them in the most 
visible part of the roof, so I need to be consistent and pretty close to 
the originals.

If I needed a large number it would be worth forging out  a male and 
female die set for my power hammer or press. From the stress marks on 
the old ones  that is how they were made. But again for ten it would not 
be worth it.

 Then I started considering a concrete female buck . Cheap, fast, 
probably durable enough.

Any one have experience down this road, or thoughts?

Mike Graf