[TheForge] Drill Press

[Darrell]

JT33 indicates a Jacobs Taper #33.
JT33 taper measures .624" at the large end and .5605" at the small end and
the tapered part is 1" long. If the hole in your chuck is not .624 at the
outside end it will not fit.

Darrell

http://www.machinemaster.com
----- Original Message ----- 
From: "Mark A. Pesetsky" <pesetsky at Princeton.EDU>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Tuesday, October 19, 2004 5:16 AM
Subject: Re: [TheForge] Drill Press


>
>
> > The Crftsman will have a chuck code( like JT33) that will tell you
> > what you
> > need.
> >
> > I've been trying to convert to keyless for years, but can't find
> > one less
> > than $300. I want a $75 one.
> >
> > dan tull
> > georgia
>
>
> Yep JT 33....So now all I need to find out is the diameter of the hole in
the ALBRECHT and order a JT33 to fit that?
>
> I did get my ALBRECHT for $75-$100 I think on e-bay...Keep looking
>
> Thanks
> Mark
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>