[TheForge] Drill Press

[Dan Tull]

Make a tool like a ball joint tool, and wedge it out.
dan tull
georgia
abba, afc, S.C. psba, obg,sofa
----- Original Message ----- 
From: "Mark A. Pesetsky" <pesetsky at Princeton.EDU>
To: "'Sponsored by ABANA'" <theforge at mailman.qth.net>
Sent: Monday, October 18, 2004 6:27 PM
Subject: RE: [TheForge] Drill Press





A lot of drill presses this size are Morse Taper number 2, but I don't
know specifically. Can you borrow an MT2 taper something or other from
someone and see if it fits?

Steve Smith



Perhaps....

The ALBRECHT chuck has a smaller diameter mounting hole...So when I find out
what I have in the press/how to get it out safely I can hopefully get what I
need...

Thanks A Lot
Mark

_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________