[TheForge] Drill Press

[Dan Tull]

The Crftsman will have a chuck code( like JT33) that will tell you what you 
need.

I've been trying to convert to keyless for years, but can't find one less 
than $300. I want a $75 one.

dan tull
georgia
abba, afc, S.C. psba, obg,sofa
----- Original Message ----- 
From: "Steve Smith" <sos at alum.mit.edu>
To: <pesetsky at Princeton.EDU>; "Sponsored by ABANA" 
<theforge at mailman.qth.net>
Sent: Monday, October 18, 2004 6:26 PM
Subject: Re: [TheForge] Drill Press


>A lot of drill presses this size are Morse Taper number 2, but I don't know 
>specifically. Can you borrow an MT2 taper something or other from someone 
>and see if it fits?
>
> Steve Smith
>
> Mark A. Pesetsky wrote:
>
>> I have a craftsman 12" drill press that i want to replace the chuck on. I
>> have a nice ALBRECHT that I want to put on it. What I am going to need to
>> know is what type of arbor is on the press. I tried calling the SEARS
>> service dept. to n avail. Has anyone here sucessfully done this type of
>> modification? Or does anyone know where I might find out what type of 
>> arbor
>> is used in this machine?
>>
>> Thanks
>> Mark
>>
>> _______________________________________________
>> Manage membership or unsubscribe at:
>> http://mailman.qth.net/mailman/listinfo/theforge
>> theforge mail list group photo site is
>> http://www.photoaccess.com
>> Login:  blacksmithblacksmith at hotmail.com
>> password:  anvil
>> ___________
>>
>>
>>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>