[TheForge] scrap plate steel

[Dan Tull]

$130 X 2.5  =$325 for 4X8?
dan tull
georgia
abba, afc, S.C. psba, obg,sofa
----- Original Message ----- 
From: "Gladish Family" <gladish at cnw.com>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Friday, October 15, 2004 11:42 AM
Subject: RE: [TheForge] scrap plate steel


> If it was before this spring, sure. But steel has more than doubled in my
> part of the world since then. Average of 2.5 times as much across the 
> board.
> Andy g.
>
>> That sounds WAY too expensive.
>>
>> My 4X8 X 1/2  NEW was $130
>>
>> dan tull
>> georgia
>
>>
>> > Is there a way to straighten steel plate?
>> >
>> > I need to extend a welding table, so went to the local supplier
>> and priced
>> > a
>> > new 4x5, 1/2". For new steel it's ninety-some cents a pound,
>> about $350...
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>