[TheForge] Gas forges

[Marc Godbout]

Thanks, and "research" away :-)

-Marc

On Fri, 2004-05-21 at 20:18, Michael H. Murphy wrote:
> That is a good, flexible design -- and good-looking to boot.  I hope you
> don't mind if I steal a couple of ideas from your design.
> 
> "Stealing ideas from one person is plagiarism; stealing ideas from many is
> research."  Can't remember the author.
> 
> Thanks for the good documentation with the pictures.
> 
> Mike Murphy
> 
> > -----Original Message-----
> > From: theforge-bounces at mailman.qth.net [mailto:theforge-
> > bounces at mailman.qth.net] On Behalf Of Marc Godbout
> > Sent: Thursday, May 20, 2004 10:19 PM
> > To: Sponsored by ABANA
> > Subject: RE: [TheForge] Gas forges
> > 
> > I used a 30lb propane tank, cut in half lengthwise then welded
> > end-to-end to make an arched roof. The roof is insulated with insulating
> > castable refractory. The walls and floor are insulating brick. All is
> > coated with ITC-100. You can see it and its construction at
> > http://ironringforge.com/NewForgeSaga/New_Forge_Saga.html

> 
-- 
Marc Godbout
http://www.ironringforge.com

New England Blacksmiths Membership Director
http://www.newenglandblacksmiths.org