[TheForge] Smallest anvil...

[H and P Foster]

Hey Andy,   I made a very small anvil for a tie pin, out of stainless.  It
was quite a bit of work, but my favorite tie pin, especially when worn with
the hammer tie pin.  Here is a link
http://pages.infinit.net/rustydog/btiepin.htm 

Harry Foster
Rusty Dog Forge

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Andy Vida
Sent: Tuesday, May 11, 2004 12:53 PM
To: Sponsored by ABANA
Subject: Re: [TheForge] Smallest anvil...



Dan Scheid wrote:
> 
> no insanity is if he hardens it them tempers it so you could forge on 
> it

	Oh, I'm already considering that.  No joke.  4140 or maybe s7,
	but you know what?  I'm not sure it will cast because of the
	surface tension of the molten metal.  Anyone know about this?

	-Anbdy
_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________