[TheForge] Survey: How high is your anvil.

Thu May 6 14:15:20 2004

actually just a bit over 6'7"

On May 6, 2004, at 1:10 PM, [email protected] wrote:

> 6'8"
>
>
>
>
>
> On May 6, 2004, at 1:06 PM, Ralph E Douglass wrote:
>
>> Rich Maynard wrote:
>>>
>>>> 860 mm translates to 33 7/8", nearly 34", making it the highest 
>>>> reported
>>>> so far.
>>>>
>>>
>>> But then I am 2010mm to go with my 860mm anvil...
>>>
>>> Rich.
>>
>> I am sorry, I am used to working with microns and angstroms.... Could
>> you convert that please.  ;)
>>
>>
>> Ralph
>> -- 
>>
>>
>>
>>
>>
>> 					
>> "Good is the enemy of Excellent. Talent is not necessary for 
>> Excellence.
>> Persistence is necessary for Excellence. And Persistence is a 
>> Decision."
>> _______________________________________________
>> http://mailman.qth.net/mailman/listinfo/theforge
>> theforge mail list group photo site is
>> http://www.photoaccess.com
>> Login:  [email protected]
>> password:  anvil
>> ___________
>>
>>
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>