[TheForge] Survey: How high is your anvil.

Wed May 5 19:27:00 2004

860mm


Richard Maynard
[email protected] 

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Bruce Freeman
> Sent: 05 May 2004 22:02
> To: [email protected]
> Subject: [TheForge] Survey: How high is your anvil.
> 
> 
> I'm working on plans for a modern "oliver" hammer to work on an existing
> anvil.  I need to know how adjustable to make it.  Please let me know
> the height of your anvil (floor to anvil plate).  
> 
> (I don't need to know your opinion on how high anvils should be.  I
> don't need to know how large your anvil is.  I just need to know the
> height of the top of the anvil over the floor.)
> 
> I would appreciate your response even if you have no interest in an
> oliver hammer.
> 
> Thanks in advance,
> 
> Bruce
> NJ
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
> 
>