[TheForge] Burners

[Dave Brown]

Kenny,

Finally got around to pulling out my set of plans.  The plans I have are 
the ones that are offered through ABANA.  In DRAWING 1 top left of the page 
is a cutaway of the burner.  Part listed as #16 is the twisted strip (0.06" 
thick) and is noted as having a 180degree twist.  Drawing 1 is a blowup of 
the upper  right quadrant of page two of the second page of prints.

Dave Brown

At 11:21 PM 3/9/04, you wrote:
>Dave Brown wrote:
>>...In the Sandia Recuperative forge design they have a twisted strip of 
>>metal in the mixing tube to induce turbulence to mix the gas...
>
>I missed this information.  It is not on the prints nor is it mentioned in 
>the description. Is this something thatMr. Gunter stated at a demo? I 
>would like to know more details about this  "twisted strip", although it 
>doessound rather simple. The forge I built works good, but better is better!