[TheForge] LG clutch question

[theforge@mailman.qth.net]

I wrote a day back that I had redone the dies on my hammer.  I'm using so much that I have noticed that the clutch is now slipping more than I like. The oil for the oil sumps on the fly wheel axle is migrating into the clutch.  This is a very old LG 100# with the clutch located between the axle supports for line drive and is one of the minimal clearance steel cone to cone clutches not one with belting or blacks.  Any ideas?
  
Trusting HIM,
Steve Rollert
keenedgeknives.com
doveknives.com