[TheForge] power hammer

Thu Jan 15 12:08:00 2004

Mark,
Sure send me a e-mail and I will be glad to answer your questions.  If you
will call the TRD 800 number and give them the part number they will be
able to find it.  A couple of people have had the same problem.  If you
have a TRD or Bimba distributor locally they can get if for you also.

Thanks
Larry Zoeller
[email protected]

> [Original Message]
> From: Mark A. Pesetsky <[email protected]>
> To: <[email protected]>
> Date: 1/15/2004 8:39:04 AM
> Subject: RE: [TheForge] power hammer
>
>
>
>
> To All,
> Do not buy the plans for the Rusty Hammer.  They are a total rip off, four
> pages with a sketch and very few dimensions.  I think they were around 18
to
> 20 bucks.  I was expecting something like the plans that Clay Spencer
sells
> for his Treadle Hammers, boy was I wrong.
>
> Thanks
> Larry Zoeller
> [email protected]
>
>
> Thanks Larry...Do you mind if I e-mail you w/questions concerning the
hammer
> that you built? The "dies" link and the
> http://www.geocities.com/zoellerforge/valve.htm link are both dead.
>
> I tried using the part # of the cylinder you have on your site on the TRD
> site and it came up as a bad part #. Do you recall what you paid for that
> cylinder?
>
> Thanks
> Mark
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>