[TheForge] WTB: Any hardy tools to fit 3/4 inch hardy hole

Wed Jan 7 07:57:00 2004

Mark:

You have (at least) two choices:

1.  Look in the phone book under "Steel Distributors
and Warehouses".  Some steel distributors will deal
with a small guy, others have a minimum order
quantity.  You will probably have to buy 20' lengths
of hot rolled, and 12' lengths of cold rolled.

2.  Many welding fabrication shops sell steel, and
don't mind dealing with the small guy.  They typically
charge more though.

Phil Rosche
Summerville, SC
--- "Mark A. Pesetsky" <[email protected]> wrote:

> How weird...I am JUST getting into this as well. I
> just built a stand for my
> anvil and I am now needing tooling. My hardy is a
> 3/4" as well. I need a
> source of 3/4" square stock so I can weld it to all
> of the heads that I have
> on hand. I will probably custom fit mine by
> heating/hammering if need be...
> 
> What are some of the sources of steel suppliers that
> you all use? I use
> ADMIRAL for 10xx and stainless, but I have not
> gotten into the mild steel
> market as of yet...
> 
> Thanks
> Mark
> 
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
> 
> 

__________________________________
Do you Yahoo!?
Yahoo! Hotjobs: Enter the "Signing Bonus" Sweepstakes
http://hotjobs.sweepstakes.yahoo.com/signingbonus