[TheForge] vent hood

Sat Jan 3 10:19:03 2004

Anything run horizontally can be wired up.
If you screw the pipe together and wire it sufficiently, I would think 
you could suspend the vertical piping and a light hood.

Mike Graf

Steve Smith wrote:

> The only use for the chimney will be my gas forge. Since I do this for a 
> hobby, I'm figuring on electric heat for the times I'm not forging. 
> Definitely a gap around the insulated pipe going through the wall.
> 
> All I need to do is figure out how to attach the bracing to the upper 
> section of pipe. Unfortunately, it looks like it will be spring before I 
> get it up (I'm in Maine).
> 
> Steve
> 
> GHS wrote:
> 
>> If you leave a bit of a gap around the insulated pipe it sounds good.
>> What else is tapped into the chimney?
>>
>>
>> Mike Graf
>>
>> Steve Smith wrote:
>>
>>> I need to do this also. I'm planning on coupling the hood passively 
>>> to an external chimney. Based on what others have done for their coal 
>>> forges, I'm using 10" single wall pipe spaced 18" from any wood. I've 
>>> got a piece of insulated pipe to go through the wall. No exhaust fan.
>>>
>>> Steve Smith
>>>
>>> Wayne Ackman wrote:
>>>
>>>> I need to build a vent hood over my gas forge.  I was wondering if 
>>>> it would require a exhaust fan in the pipe to pull the CO out.  If 
>>>> so, what kind of CFM does it need to draw?
>>>>
>>>> Does it make any difference if I take it thru the roof and thru the 
>>>> wall?
>>>>
>>>> design suggestions are most welcome.  :-)
>>>>
>>>>
>>>> Wayne
>>>> _______________________________________________
>>>> http://mailman.qth.net/mailman/listinfo/theforge
>>>> theforge mail list group photo site is
>>>> http://www.photoaccess.com
>>>> Login:  [email protected]
>>>> password:  anvil
>>>> ___________
>>>>
>>>>
>>>>
>>>
>>> _______________________________________________
>>> http://mailman.qth.net/mailman/listinfo/theforge
>>> theforge mail list group photo site is
>>> http://www.photoaccess.com
>>> Login:  [email protected]
>>> password:  anvil
>>> ___________
>>>
>>>
>>>
>>>
>>> _____________________________________________________
>>> This message scanned for viruses by CoreComm
>>>
>>>
>>
> 
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
> 
> 
> 
> 
> _____________________________________________________
> This message scanned for viruses by CoreComm
> 
> 

-- 
  Please visit us at http://www.gaudeteforge.com/