[TheForge] OT - Mylar
Tim Underwood
[email protected]
Fri Feb 6 15:30:05 2004
Dave,
I'm not sure if mylar will shrink fit or not.
How about a shiny helium balloon.
Or http://www.surplussales.com/RF/RFTeflon-Mylar_sht.html
$10.00 minimum order
Tim Underwood
Sugar Hill Forge
[email protected]
> [Original Message]
> From: Dave Brown <[email protected]>
> To: TheForge <[email protected]>
> Date: 2/6/2004 1:42:01 PM
> Subject: [TheForge] OT - Mylar
>
> This is a bit off topic, but there are so many people on this list of
> varied talents and professions that I figure that there has to be someone
> here familiar with Mylar.
>
> Can Mylar be shrink fit? Think drum or pipe end here. Can you shrink
fit
> Mylar over the pipe end and heat shrink the wrinkles out of it where they
> form around the sides?
>
> Where would one get small sheet (say 18"sq) of Mylar?
>
> Dave Brown
> Heritage Smithing
> Green Bay, WI
>
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login: [email protected]
> password: anvil
> ___________
>