[TheForge] brass hand rail

[Andy Vida]

Ries Niemi wrote:
> 
> One reason you would want to forge brass (bronze) hand rail is so you
> dont have to deal with the mismatched alloys you get when you mix pre
> made ends with a factory made handrail profile. Often it is hard to get
> them to match, as micheal wolfe just mentioned. If you forge it, you
> make everything from the same alloy, same batch.

	Or perhaps a preferable alternative, though a pain in the
	butt, is to order extra rail and use it as casting stock
	and cast your own parts.  More expensive?  Sure, but I'd 
	bet casting a few odds and ends is cheaper than forging
	and finishing yards of brass rail.  If you have a hot
	mill and the right dies, this all goes out the window,
	of course. :)

--
	-Andy V.

There's a brand new talk, but it's not very clear,
That people from good homes are talking this year.
It's loud and it's tasteless, I've not heard it before.
They shout it while they're dancing from the dance floor.