[TheForge] Bull Hammer??

Tue Apr 13 07:37:01 2004

Yep, should have said SAE 10 non detergent.
Dave
----- Original Message ----- 
From: "GHS" <[email protected]>
To: <[email protected]>
Sent: Monday, April 12, 2004 9:48 PM
Subject: Re: [TheForge] Bull Hammer??


> I'll have to check my oil container, but I think the bull takes lighter
> than that in the mister.
>
> Mike Graf
>
> David E. Smucker wrote:
>
> > Wayne,  Have you provided any lubrication to the incoming air supply?
> > Sounds to me like your valve is sticking and frees up when you have
given it
> > some action.  This is a common problem I had with my air hammer sometime
> > back.  To fix you will need to shut off your air supply.  Open the line
and
> > add some lubrication.  Air tool oil is good but SAE 30 NON detergent
will
> > work too.  I added a by pass loop to mine so I could put in a squirt of
oil
> > from time to time without breaking the supply line.  Give it a try.  The
oil
> > is good for the cylinder seals too -- just don't over do it.
> >
> > Dave Smucker
> > ----- Original Message ----- 
> > From: "Wayne Ackman" <[email protected]>
> > To: <[email protected]>
> > Sent: Monday, April 12, 2004 9:08 PM
> > Subject: [TheForge] Bull Hammer??
> >
> >
> >
> >>I have a Bull 75 hammer that has developed a wrinkle.  I have tried to
> >>contact BullHammer but they don't respond to emails and the phone number
> >>has been disconnected.  Any one know what happened to them?
> >>
> >>In any case, my hammer works fine, then after sitting a bit before I get
> >>back to it, it will require that I step on the treadle 2-3 times to get
> >>it to cycle.  Works fine then, but the issue repeats if I let it alone
> >>awhile before I get back to it.  If there is a fix generic to air
> >>hammers, I would appreciate any suggestions.
> >>
> >>Wayne
> >>_______________________________________________
> >>http://mailman.qth.net/mailman/listinfo/theforge
> >>theforge mail list group photo site is
> >>http://www.photoaccess.com
> >>Login:  [email protected]
> >>password:  anvil
> >>___________
> >>
> >>
> >>
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://www.photoaccess.com
> > Login:  [email protected]
> > password:  anvil
> > ___________
> >
> >
> >
> >
> > _____________________________________________________
> > This message scanned for viruses by CoreComm
> >
> >
>
> -- 
>   Please visit us at http://www.gaudeteforge.com/
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>