[TheForge] Re: (no subject)

[theforge@mailman.qth.net]

"There has been a lot of talk on this list about burners.  Lately the use of
flares on the end has been discussed.  I don't remember any talk on things
to aid in the mixing.  Have any of you tried this and has it made a
difference?"

Robert Ehrenberger
Shelbyville, Mo. 

You might consider using a very loosely coiled wire held by spring tension on 
the inside of the mixing tube instead. This will induce spin, and spinning 
the gas/air flow is the key to making a good mix while interfering least with 
flow speed. No more than one complete turn in four inches down the coil. If you 
interfere very much with flow speed, the burners will become even weaker.
Mikey


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---