[TheForge] Candle cups

Wed Sep 10 08:38:00 2003

Why not make your own from a piece of copper tube?  Its not too tough.
Just work the bottom down to size w/ a 1/2" spring fuller and flair the top
on the horn of the anvil.  Work at a low red heat or cold and anneal often.
Randy Mundt
----- Original Message -----
From: "Gabriel Cain" <[email protected]>
To: <[email protected]>
Sent: Tuesday, September 09, 2003 10:09 PM
Subject: [TheForge] Candle cups


>
> Hello all.
>
> Does anyone have a source for copper candle cups?  I've spent a while
> searching, but I havne't found any sources.
>
> Much appreciated,
> Gabriel
>
> --
> Gabriel Cain Systems Administrator and
> (425) 774-4879 Chief Artifacer
> [email protected] Dreaming Crow Forge
>
> http://www.dreamingcrowforge.com - Take a look =)
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>