[TheForge] Plasma cutter comparison

Sun Oct 26 07:39:00 2003

Dan,  I've had real good luck with my ESAB plasma cutter.  It is six years
old, no problems.

Ralph

----- Original Message -----
From: "Dan Armstrong" <[email protected]>
To: <[email protected]>
Sent: Friday, October 24, 2003 2:01 PM
Subject: [TheForge] Plasma cutter comparison

> I'm in the process of comparing the following plasma cutters for eminent
> purchase:
>
> Lincoln Pro-Cut 25
>
> Hobart Air Force 400
>
> Hypertherm Power Max 380
>
> My price range is $1200. - 1300. (US) and 3/8" max. cutting ability is
> plenty.
>
> Anybody have any experience/information or other suggestions to share?
> Or perhaps knowledge of consumer report info on same?
>
> Thanks.
>
> DanA
>
>
> ----- Original Message -----
> From: "Cameron Stoker" <[email protected]>
> To: <[email protected]>
> Sent: Friday, October 24, 2003 10:23 AM
> Subject: Re: [TheForge] Responses to "Possible new TH design"
>
>
> > Thought I should respond to this thread -
> >
> > I bought a set of plans from Bruce several years ago for the
> > grasshopper hammer, and they sat quietly for some time, but about a
> > month ago I ended up needing to clean out my scrap pile, and realized
> > there were many shapes of stock appropriate for the GH. Spent about
> two
> > and a half weeks of more off than on working at building the
> > grasshopper hammer, and finished it about the beginning of this month.
> > I took some photos of the building at several stages, and one or two
> of
> > the finished hammer. I'll see about posting them to the photo site.
> >
> > I have since been very busy and haven't been working on projects where
> > a treadle hammer was the appropriate tool so I have probably only used
> > the hammer for about an hour.  The bearings are just starting to
> > break-in and get really smooth - I sometimes just bounce the head a
> bit
> > while waiting between heats because it's fascinating to watch the
> > mechanism work.
> >
> > I think this hammer will really come into its prime when I've had time
> > to make a few die sets. I mainly just used it with some top tools over
> > a lead block to clean up lines in some bronze repouse. Very nice to
> > have the all the adjustments available.  The action is very smooth.
> >
> > Thanks Bruce
> >
> >
> >
> >
> > Cameron Stoker
> > [email protected]
> > "May you run like a vicu�a!"
> > pgp key @ http://keys.stoker.net
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://www.photoaccess.com
> > Login:  [email protected]
> > password:  anvil
> > ___________
> >
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>