[TheForge] Platten table hammer in clamps?

Wed Oct 22 19:35:00 2003

Hey some interesting ideas on those 2 websites, this is a must see I think
http://www.weldsale.com/pdfs/ToolsClampsWS_Cat2002.pdf  380Kb (small)
a .pdf (need acrobat reader) of weldsales' platten accessories, some cool
stuff in there, scissor lift for you platten table WOW.

----- Original Message -----
From: "Ries Niemi" <[email protected]>
To: <[email protected]>
Sent: Thursday, October 23, 2003 3:11 AM
Subject: Re: [TheForge] Platten table hammer in clamps?

>
> Shannel-
> I find it usually helps to start with a design that already works, then
> hopefully improve from there.
> In that spirit- you ought to look at the commercially available platen
> table accessories. You can usually reverse engineer from looking at
> them.
>
> try
> http://www.acorniron.com/products/
> or
> http://www.weldsale.com/
>
> looks like you could make some nifty clamps pretty easily as well.
>
> ries
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>