[TheForge] Platten table hammer in clamps?

[Peter Fels And Phoebe Palmer]

Shannel:
A piece of bar stock a little smaller than the hole size and bent in the 
shape of the number "7 " with a longer top leg and a slightly sharper 
angle is the most common one I've seen. Just hammer them tight by 
striking the angle  above the hole..to loosen, strike the angle from behind.
These don't seem to do well on a short reach, the legs need to be fairly 
long.
These are dogs you can beat without do-gooders complaining....Pete F

shannell wrote:

>Anyone got a hot tip on how to make a quick and easy platten table clamp
>that hammers in? Ive been playing for the last 10 mins on the table with
>some ideas and Im coming up with something but theres probably some
>ingenious contraption already discovered?..... Ive been playing with table
>pins and an anvil clamp that hammers into the pritchel hole....
>
>_______________________________________________
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith@hotmail.com
>password:  anvil
>___________
>
>
>
>  
>