[TheForge] Pipe Miters

Sun Nov 16 16:56:01 2003

Not the same, although I looked at the ihpva site for it.  It was 
written by a ihpva member I think, in 1995.  It tends to make my 2000 
system act a little wonky when it is running and takes forever to close, 
but works otherwise.  Norton says its clean of viruses.   It goes to 10 
in diameter in fractions, and for decimal entry I don't know what the 
limits are.   It also handles offset, which tubemiter does not.  As I 
stated it is on the yahoo group theForgeFiles now.   I have also sent it 
to a couple of other people on the list to post on their sites.

Charles

Burch wrote:

> Is it similar, or possibly the same one as the tubemiter.exe on this 
> site?
> http://www.ihpva.org/tools/index.html
>
> This is a bicycle building site, so the tube sizes may be too small 
> for most of this audience.
>
> Terry
>
>
> At 03:11 AM 11/16/2003, you wrote:
>
>> It is in the members only files area of a small specialized yahoo 
>> group ( airplane building), so it would require everyone here to 
>> create a yahoo ID and sign up and be approved, and would require the 
>> moderator of that group to wade through all of the signups. I have 
>> searched several shareware sites and did a google, but couldn't find 
>> a good url for it.   If no one has a better place, I will put it on 
>> the rec.crafts.metalworking dropbox list, just a litle more painful 
>> to get to and have to know exactlt what you are looking for to get it 
>> there.
>>
>> Charles
>
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>