[TheForge] I made a 30 ft Gate

[Mark A. Pesetsky]

Hey all,
       I just finished a gate for the Audubon Society in Milwaukee. =
Check it

out. =20

http://www.irontreeworks.com/AudubonDan.jpg
http://www.irontreeworks.com/Audubongate.jpg

The hardest part was making a 2 ft circle out of 3/4 inch square stock.  =
The

disk behind the circle is made from 16 ga Stainless steel sheet.  The =
eyes
and=20
nose are attached to the stainless using using pop rivets.=20



WOW...VERY IMPRESSIVE....You must feel quite good about that job
Dan...Thanks for sharing and keep up the GREAT work..

Mark