[TheForge] Swedge block stands

Thu May 8 22:08:01 2003

    I have mine on a utility pole set in the dirt floor of the shop.
I am considering cutting a groove down the middle of the top
with a chainsaw, the width of the block so that it will set on edge
and still be about the same height as when flat.
    My post vice is also mounted on a utility pole with one side
cut down to a shelf near the bottom to set the post on. This allows
one access from all side of the vice or to walk around it when
bending things.

Bob Willman
The Eagle's Anvil
Bowling Green, Ohio
WB8NQW

----- Original Message -----
From: "Bob Rackers" <[email protected]>
To: "TheForge" <[email protected]>
Sent: Thursday, May 08, 2003 21:34
Subject: [TheForge] Swedge block stands


> I'm searching for ideas for stands for a swedge block.
> Ideally wood since I don't weld, but I'll look at all good ideas.
> I'm curious to know if anyone has made a stand to hold the block on both
the
> face or on edge.
>
> Thanks
>
> Bob
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>