[TheForge] Power Hammer Power

Tue Jun 17 05:22:04 2003

John,
You might want to add a flywheel into the setup. A line shaft would also 
help. Old shops that used these had a long line shaft with a bunch of take 
off pulleys which adds up to having a lot of spinning mass, like a flywheel
Larry

At 07:58 PM 6/16/2003 -0400, you wrote:
>It might run, hit or miss!
>;-)
>Larry Brown
>
>
>At 03:32 PM 6/16/2003 -0400, you wrote:
>>Has anyone on the list ever tried using a hit or miss engine to run a
>>small power hammer, some thing the size of a 25 Lb little giant, and if
>>so were there any problems??
>>
>>Thanks in advance
>>John C. in NJ
>>
>>_______________________________________________
>>http://mailman.qth.net/mailman/listinfo/theforge
>>theforge mail list group photo site is
>>http://www.photoaccess.com
>>Login:  [email protected]
>>password:  anvil
>>___________
>
>
>_______________________________________________
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  [email protected]
>password:  anvil
>___________
>