[TheForge] Forging Hammer For Sale

[mike wolfe]

Forging Hammer for sale:
Beche L6 two-piece Forging Hammer For sale
A self-contained air hammer.
330-pound Ram at 180 Beats per minutes
Main frame 7000 pounds
Anvil 3000 pounds
15 HP. 220v 3 phase motor with starter.
It also comes with a 20 hp rotary phase converter.

This hammer is up and running and functions very well.

This hammer has a new set of dies made by Bob Bergman in Wisconsin.
The die are set up as a combination die 3� x 8� flat die with a sharper 
section at one end.

The Beche was the hammers that the Nazels and Chambersburg were designed 
from.

This a German made hammer of exceptional quality.
This hammer sat for 5 years unused and we took it apart to see if there 
was any rust or damage inside.
Every moving surface inside was still highly polished and as smooth as a 
babies butt.
We put it back together and turned it on and it ran great..and is still 
running great.

It can se shipped across the country for less than 1000.00 I had it 
shipped 1400 miles for 600.00.
You just contact a �less then normal load carrier� They chain it down to 
a flat bed and in two or three weeks you will have it at your door.

You then call a local wrecker service to send a �Expressway large truck 
wrecker� and they will off load it and place it for under 100.00 dollars.

I am asking 14,600. (Firm) for this exceptional hammer.
Photos will be posted tomorrow .

Please contact Mike Wolfe Via E-Mail at mwolfe@bigcat.net
Or call me at 734 668-0404 Ann Arbor Michigan