[TheForge] Cylinder Size

Tue Jul 15 08:05:00 2003

        Bob, If I make an adustable slide for the limit switch...........the
stroke can be adjusted to fit the stock one is working.  You only need the
5" to work on flat bar and general hardware of 3/16 -3/4 stock...........but
if old full height tools are used one could move the stroke to the full
range, but only be still using the top 5" of it to strike the full height
tooling.  (at least that's the plan - and should use the same amount of
air).
        I had such a serious work load late spring/early summer that I had
to drop the list for a while to keep up with business.  I'm caught up - so I
figured I'd listen in again........and pipe up when I find one I can answer.
:-)

Ralph
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Monday, July 14, 2003 4:46 PM
Subject: Re: [TheForge] Cylinder Size


> >
> >I'm going to try  using a 2 1/2" cylinder with 20" stroke next round.
> >
> >
> >Ralph
> _____
>
>
>
> Ralph,
>
> That will take a serious air supply. Nice to see you back on theforge.
>
> Bob Schade
>
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>