[TheForge] Sidearm Burner Parts

Wed Jan 15 20:39:01 2003

hmmmm mabey copper??

----- Original Message -----
From: "Shannell Sugrue" <[email protected]>
To: <[email protected]>
Sent: 16 January, 2003 11:53 AM
Subject: Re: [TheForge] Sidearm Burner Parts

> Well Ive found everything except the 1/8" pipe that the mig tip screws
into.
> 1/8 and even 1/4 inch pipe doesnt seem to even exist here in south
> Australia, amazing for a place that is supposed to be the engineering
> capitol of Australia. I thought of using brake line but the wall is too
> thin, anyone got any suggestions, 1/2" with a reducer for the tip might
work
> I suppose.
>
>
> ----- Original Message -----
> From: "Stephen McGehee" <[email protected]>
> To: "The Forge" <[email protected]>
> Sent: 15 January, 2003 8:51 AM
> Subject: [TheForge] Sidearm Burner Parts
>
>
> > In my understanding of Pipefitters Terminology, Tee's are described as
> > the two straight-through hubs, then the tap, hence the tee that is used
> > with this burner is a 1-1/4 by 3/4 by 1-1/4 inch.  Sometimes those
> > counter guys are so inflexible as to say "we ain't got any of them",
> > when in fact you just asked for the wrong part...  Taking a full sized
> > 1-1/4" tee and bushing it down should work.  (Dan Scheid) responding to
> > this thread said he was using 6# of propane, but when I saw Larry
> > Zoeller demo his unit at Quad State, he was using 8 ounces of pressure
> > for what seemed like a respectful output; what size tip orifice are you
> > using?  And does your unit just require that much pressure to get a
> > welding heat?  Pardon me for not following this thread back when it
> > started, Dan, but what size furnace do you have, inside and outside
> > measurements and material?  Thank you.
> > Stephen McGehee
> > Publisher of
> > Irony, the sketchbook of an apprentice blacksmith
> > P. O. Box 9822  Pine Bluff, AR 71611
> > [email protected]
> > (870) 540-0142
> > (479) 643-3299 (farm)
> >
> > (you can see a sample of Irony here:
> >
> > http://lametalsmiths.org/news/page4.htm )
> >
> >
> >
> >
> >
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://www.photoaccess.com
> > Login:  [email protected]
> > password:  anvil
> > ___________
> >
> >
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>