[TheForge] Swage block

[Mike Linn]

That was my stand and the photos are posted on photo site listed at the 
bottom of this email. Look under tooling on pages 2 and 3

mike




At 01:02 PM 02/21/2003 -0600, you wrote:
>In June 2002, someone on this list posted  photos of their  Swage block 
>stand.  It was built so that  any working surface of the swage block would 
>be at the same height.    I just  found the photo on this computer. there 
>was a  drop slot so that it could be used "one end" , a different level 
>for "on- side" or the top level  "on flat".
>
>Dann Johnson

         Michael Linn
       Artist Blacksmith
      McCalla, Alabama
       AFC Webmaster
http://afc.abana-chapter.com