[TheForge] Pulleys
Steve Smith
[email protected]
Sat Feb 15 23:34:01 2003
Last time I checked, V belts were considerably cheaper.
Steve
Cameron Stoker wrote:
> My pulley an belt setup cost about $45. This sure beats the canvas belt
> I put on first which cost about $30 + several hours machining a crowned
> drive pulley and the belt would slip whenever it got too oily.
>
>
> On Saturday, February 15, 2003, at 08:03 PM, Steve Smith wrote:
>
>> I can guess that you haven't seen what toothed belts and pulleys cost.
>> You may decide that V belts (which work fine) are a better option.
>>
>> Steve Smith
>>
>> DragonsWatch wrote:
>>
>>> Well, the way I figure it, I gotta have something, and as I have
>>> nothing,
>>> then why not? It seems to work and that's what matters. I know a
>>> simple V
>>> belt will work, but then so might a hemp rope, or a leather belt.
>>> Larry
>>> "Walter L. Mullett" wrote:
>>>
>>>> Why? You really don't need that.
>>>>
>>>> Walt
>>>> -----Original Message-----
>>>> From: DragonsWatch <[email protected]>
>>>> To: [email protected] <[email protected]>
>>>> Date: Friday, February 14, 2003 10:27 AM
>>>> Subject: [TheForge] Pulleys
>>>>
>>>>
>>>>> I think I asked this before, but can not find it or any replies.
>>>>> Somewhere here I saw a picture where a tooth belt was used to drive a
>>>>> LG hammer. Does anyone know of a source of these belts and pulleys?
>>>>>
>>>>> Thanks,
>>>>>
>>>>> Larry
>>>>>
>>>>> _______________________________________________
>>>>> http://mailman.qth.net/mailman/listinfo/theforge
>>>>> theforge mail list group photo site is
>>>>> http://www.photoaccess.com
>>>>> Login: [email protected]
>>>>> password: anvil
>>>>
>>
> Cameron Stoker
> Stoker Forge
> [email protected]
> pgp key @ http://keys.stoker.net
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login: [email protected]
> password: anvil
> ___________
>
>
>