[TheForge] Water vapor plasma tool

Tue Feb 11 21:15:01 2003

http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/message/55248
I think you can read these without being a member.

----- Original Message -----
From: "Ralph Sproul" <[email protected]>
To: <[email protected]>
Sent: 12 February, 2003 11:37 AM
Subject: Re: [TheForge] Water vapor plasma tool

>         Shannell, Thanks for this address.  If you find out more about
this
> tool, please let me know.  I'm curious for sure as to how it works.    How
> did you know it is cheap? do you have some cost of the basic unit?
>
> Ralph
>
>
> ----- Original Message -----
> From: "Shannell Sugrue" <[email protected]>
> To: <[email protected]>
> Sent: Tuesday, February 11, 2003 6:24 PM
> Subject: [TheForge] Water vapor plasma tool
>
>
> > http://home.ptt.ru/alplaz/Ge.htm
> >
> > Anyone tried one of these? Its like a plasma cutter but uses water vapor
> > instead of air. Says it can cut concrete, glass, steel, nonferrous etc,
> only
> > 6mm in steel though. Cheap too. Just wondering what they are like.
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://www.photoaccess.com
> > Login:  [email protected]
> > password:  anvil
> > ___________
> >
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>