[TheForge] 36" diameter ring

Tue Aug 5 22:32:00 2003

It depends on what you're calling on the flat or on the edge.
Let's just say it's the easier of the two.

It's to hold a large copper kettle (probably an apple butter kettle).

So Kevin, how do you determine how much is the right amount to pull each time?
Do you check it after the first pull or two, then adjust from there?

Bob

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Kevin donahoe
Sent: Tuesday, August 05, 2003 9:59 PM
To: [email protected]
Subject: RE: [TheForge] 36" diameter ring

Bob, when's the wedding? :)... OK, is the ring on the flat or edge?

Actually, doesn't matter. Take your ten+ feet of stock mark it every two
inches, place each mark on the same place of the stationary bending fork and
working fork and make approximately the same pull/motion at each two
inches... just alittle motion each time.

Kevin Donahoe
Flying Pig Forge
Morrow, OH
[email protected]

"Every Communist must grasp the truth: 'Political power grows out of the
barrel of a gun." - Mao Tse-tung, 1938