[TheForge] Molloch Trip Hammer

Thu Nov 28 07:02:00 2002

        Keith, I'd start with a 2hp 1750 rpm motor.  You can use a 3600 rpm,
but you'd have to do a jack shaft to cut the speed so the hammer
crank/flywheel turns around 300-350.

Ralph

----- Original Message -----
From: "Keith Holmes" <[email protected]>
To: <[email protected]>
Sent: Wednesday, November 27, 2002 12:20 PM
Subject: [TheForge] Molloch Trip Hammer

I have a purchased a 50lb Molloch trip hammer and I am trying to get it up
and going. Can anyone tell me what speed electric motor I need to used for
the drive motor?

Keith Holmes

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---
_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  [email protected]
password:  anvil
___________