[TheForge] nails
Dan Tull
[email protected]
Sat Nov 9 16:41:02 2002
Header needs to be "relieved" around top as well as the bottom.
Drive in square taper from bottom, then just tap it in from the top
leaving "bottom heavy" hour glass shape in bolister.
Yes, they should fall out.
dan tull
georgia
abba, afc, S.C. psba, obg,sofa
----- Original Message -----
From: "John Chobrda" <[email protected]>
To: "The forge" <[email protected]>
Sent: Saturday, November 09, 2002 4:25 PM
Subject: [TheForge] nails
> OK, spent most of today trying to make a nail header an nails. I
> have been to many demos where a nail is forged, cut off of the rod, put
> in the header, headed, the header turned over and the nail FALLS out.
> Every nail I made today had to be hammered out, any ideas.
>
> Thanks in advance
> John C. in NJ
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login: [email protected]
> password: anvil
> ___________
>
>
>
>