[TheForge] Benders

[Jay Hayes]

Bill,

I have both the Hossfeld and DiArco. The Hossfeld is in my opinion a more
versatile machine. It is easier to set up and has a larger capacity. The
dies are also cheaper and there is a broader selection.

The Diarco on the other hand has its good points too. It is geared more for
making precise bends in lighter material with a higher degree of
repeatability. The dies are of a higher quality and the arm can swing bends
over 360 degrees.

For bending mid sized quantities of small parts the Diarco is the winner.
The Hossfeld is better for small quantities of  parts in a wider array of
material.

If I were to start over, I would go for the new hydraulic bender from D
squared. Their dies are cheaper than Hossfeld and works of art.

Hope this helps.

Jay Hayes

Woolley wrote:

> Greetings,
>
> I was wondering if anyone has experience with Diacro #2 and Hossfeld #2
> benders?  I've used a Hossfeld and I know Diacro has a good reputation
> just wondering if anyone has specific ideas on how they compare.  Die
> price, ease of use, anything.  There is one listed at an upcoming
> auction around my way.  If the selection of dies is good and it is in
> good overall condition at a good price it will be a no brainer.  Just
> throwing it out there since I've seen a couple threads on Hossfeld but
> not much mention of Diacro if my memory serves me well.  Thanks.
>
> Regards,
> Bill Woolley
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith@hotmail.com
> password:  anvil
> ___________