[TheForge] Re: Demos

[Roger R Degner]

If you have a vertical band saw or a lot of patience with a hack saw precut
using 1/4 or 3/8 square stock.  I have the dimensions written somewhere or
it is on one of the UMBA tapes for the length of stock and cuts.  Then at
the demo stick the stock in the forge pull it out and almost magically it
becomes a cross with only two quick bends.  The turtle man had examples of
them at Lacrosse.
I think they brought $40 at the auction.  In less economically challenged
areas you can punch a hole add a round link which attaches them to a premade
leather necklace for up to $40 before they cool according to the tape.
Notice the repeated commercials for the UMBA library at www.umbaonline.org
Roger R Degner
Franklin,Minn,USA
> Hmmm, another idea that can be sorta quick, make a friend Cross'  take a
> piece of 3/4 stock using a hot cut split it down about 2 inches. turn over
> 90 degrees and split from the opposite end as the first cut. Be sure the
> cut goes past the first by about 1/2 inch. Then unfold and you have a nice
> cross .......   You can use smaller stock but I have a harder time with
it.
>
> Ralph
>