[TheForge] Work Table (was Shop Cleanliness)

Wed Jan 23 13:52:44 2002

If you sometimes need a larger table, or require a table you can role out of
the way, why not make a table to the size you normally use, or the width you
can store, and put leaves on the side with swing out legs to increase your
work area.  Just a thought.

Paul McComb
Fat Raccoon Forge
[email protected]

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Larry
Sent: Wednesday, January 23, 2002 7:53 AM
To: [email protected]
Subject: Re: [TheForge] RE: ] Shop Cleanliness

I just wish I had room for a table like this.  Much less all the cool toys
in
the back ground.

Jealous

Ralph Sproul wrote:

>         Ray, Bob, and all,   I have grown tired of the grinding dust in my
> helmet or resperator being full of crud when I go to use it, all my flat
> surfaces clutered every time I go to weld or work on a table..........so I
> came up with the answer to table storage and spend a whole lot less time
> running around the shop looking for the tape I set some where, the
soapstone
> "I just had", the clamps or V blocks I need, or the speed square, combo
> square, etc.

_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  [email protected]
password:  anvil
___________