[TheForge] Anvil Repair

[Larry]

Thanks Steve,
    Do you know how thick the steel face is on a PW?  The edges have taken
some serious abuse, and I don't think it has ever been repaired before.
    The Dudley-Wright has signs of repairs.  I wonder if it was built the
same way, steel on wrought iron.  If so, then the same info would apply.

    So to heat an anvil to 300 degrees without taking it into the wife's
kitchen...........  Set it on the forge and keep the air low? hum.

Thanks,

Larry

Steve Smith wrote:

> It sounds like you're not going to do the welding yourself; plenty of
> advice around theforge if you are.
>
> The difficulties I've seen come from the different types of steel and
> iron in the anvils. For instance, Peter Wrights have a hard top plate
> welded to a wrought iron body. The two materials need different rods for
> a successful weld. A good welder (without specific anvil experience)
> should be able to figure out rods that will stick (experimental process
> at worst). You not only have to make successful welds, you need to use a
> rod material that will hold up under typical use.
>
> The repairs I've done were with Stoody 1105 and 2110 rods. The 1105
> sticks well to the body of a PW, the 2110 works well on top. The 2110
> comes out just a little soft in my mind, but on the other hand it
> doesn't seem to chip. These aren't cheap rods.
>
> You must preheat the anvil before welding (300 degrees works, don't get
> up to 400 or you will start to lose your temper!).
>
> Steve Smith
>
> Larry wrote:
>
> > I have 3 anvils, a Peter Wright, a Dudley-Wright, and a
> > Hey-Budden.  All have various signs of mis-use and abuse.  I
> > was wondering what I need to know and avoid when having
> > these repaired/restored for use.  Is there someone in
> > central Texas that does this kind of work?
> >
> > Thanks,
> >
> > Larry
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://www.photoaccess.com
> > ___________
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> ___________