Fw: [TheForge] gas burner design

Wed Jan 2 20:15:01 2002

> Rat's Bob!  Nobody told I couldn't do use it to heat up big and/or
irregular
> stock. I'll stop immediately.
> If you cut a stock opening 6" high and 270 degrees around with hinged
doors
> to close up 80% of the opening you would be surprised at how much
irregular
> stock will fit in the D F Forge.
> Use 16 "pipe with 1/4" wall thickness for strength and anchor the 1"
inswool
> to the top, walls and doors with sheet metal screws dipped in satenite and
> then screwed thru pre drilled holes, in the metal skin, into the wool.
> Regards,
> Chuck

----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 01, 2002 8:10 AM
Subject: Re: Fw: [TheForge] gas burner design


> Don Fogg style forge is made for blade smithing and not for irregular and
> somewhat large shapes done when doing decorative blacksmithing
>
> Bob
> HotAnvil Forge
> http://www.geocities.com/hotanvil
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://albums.photopoint.com/j/AlbumList?u=1169182
> ___________
>
>