[TheForge] gas burner

[Ralph Sproul]

        Just posted a picture of a decent burner design all made from 1"
pipe fittings and a stainless steel flare I made on the press.  Burns well
from 2-15 psi so it should work well on the idle circuit of the new forge
I'm building.  The picture is under the shop pictures heading.  Ideas for
slots, jet injected, and flares all from Ron's Reil's page.   I found the
3/4" pipe burners didn't have the heat for the open chamber forge I've
built.

Ralph Sproul - Bear Hill Blacksmith
Webster, NH