[TheForge] Torch Stuff

[Peter Fels and Phoebe Palmer]

Sorry Norm, missed your post...
The joints that hold the tubes from the cutting head to the body on most 
cutting torches are just silver soldered..should be easy to re 
configure...low buck approach.
As for cutting pyramids...I have a little pile of  diced pieces from a 
small H beam for that. They are steady, all the same height  and disposable.
Sure do appreciate you blacksmithing books service!.....
( you owe me a nickle)          Pete

>I sent in a post a few days ago inquiring about converting a oxy-
>acet. torch to a barrel torch and also about "pyramids" to put on a
>cutting table to keep from damaging the cutting surface.
>
>There were a few responses to this inquiry on theforge but
>somehow I've lost several emails including the responses I was
>interested in.
>
>If these members would email me what they said I'd sure
>appreciate it.  I remember one response mentioned something
>about an article that appeared in the HSM magazine.  Thanks.
>
>Norm Larson
>
>_______________________________________________
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith@hotmail.com
>password:  anvil
>___________