[TheForge] 3 Phase Converter DIY

Fri Dec 6 02:48:01 2002

There is a simple schematic on the DEMO Files page at
http://www.machinemaster.com

Darrell

----- Original Message -----
From: "Ed F" <[email protected]>
To: <[email protected]>
Sent: Thursday, December 05, 2002 4:42 PM
Subject: [TheForge] 3 Phase Converter DIY


> I want to look into making a 3 Phase converter to run a 3 phase forging
> press motor off of 220 single phase.  I can get away with a 5 hp but I
will
> probably go to a 7.5 hp.  I ordered the plans from ABANA way back  and
lost
> them.  I remember them  being about 3 pages and on the minimal side.  I'm
> thinking that by now someone probably has better directions on the web
> somewhere, or maybe someone here is willing to share experience?
>
> Ed
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>