[TheForge] Miller Welder

[Ray Miller]

Jeff,
You might challenge the dealer you bought the 185 from. Miller was 
selling the 210 with a free Spoolmate spool gun through the end of 2001, 
and because it was such a great deal many welding supply houses around 
here ordered dozens of extra units because they knew they could sell 
them. (I picked up one for my step-dad in-law, really). In fact there 
were a number of the 210s with spool guns on ebay the went for $1190.

I don't mean to say you didn't do well, but to see if you can get a 
spool gun out of the dealer,

Ray
Cincinnati

Jeff Harding wrote:

>I just bought a new Miller 185, (won't pick it up until I finish the
>drywall), the speed/heat range guide list settings for stainless up to
>3/8".  The heaviest stainless I plan on using is 1/8", so that should
>do me.  Miller has replaced this with it's new  210 model. This one
>was used for 10 minutes, I paid $1180 for it,  how'd I do?
>
>   I'm gonna buy an extra torch for it and have the gas for stainless
>sitting on the side, will take longer to change over than buying a
>spool gun, but I'm not doing production welding.
>
>   Anyone have any experience with the Lincoln auto helmet that goes
>for around $140 and operates on photo cells?   I know a better helmet
>is worth it's price, but again, I'm not doing any production welding,
>just fabrication and repair of my manufacturing equipment.
>
>   Any and all comments and advice always welcome!
>
>   Jeff   ><>
>
>_______________________________________________
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith@hotmail.com
>password:  anvil
>___________
>
>
>