[TheForge] Air hammer dies.

[GHS]

Slick

Mike Graf

Dan Scheid wrote:

> I Weilded angle iron to the ram. Making a L then slide in plate use a bolt
> latch to keep from sliding back out
>     XXXXXX                XXXXX
>     XXXXXX                XXXXXB
>     XXXXXX                XXXXXB
>      [--------]                L\\\\\\\\\\\\]B
>  Front                            Side with B as bolt
> I just looked at my web site an sorry to say you can't see it on those pic.
> so have to just use the asci art
> Dan Scheid
>
> > >don't think so. the LG. are dovetailed don't know the others. I went with
> a
> > >slip die much faster to change then a bolt
> > >Dan Scheid
> >
> >
> >
> > dan,
> >
> > i'm not familiar with what you call a slip die. care to add any details?
> >
> > bob s.
> >
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://albums.photopoint.com/j/AlbumList?u=1169182
> > ___________
> >
> >
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://albums.photopoint.com/j/AlbumList?u=1169182
> ___________

--
my website is http://www.execpc.com/~ghs/