[TheForge] (no subject)

Tue Dec 11 15:48:00 2001

Sure.  Insert a square tube with 1" square intside.  Or insert an angle iron with 1/4" thickness.
Bruce
NJ

>>> Frederick Faller <[email protected]> 12/11 2:42 PM >>>
I have just installed my new old anvil and am
chagrinned that the hardie hole is 1.25" rather than
the 1.0" hole I have in my Peter Wright. Is it
reasonable to make an adapter so I don't have to make
all my hardie tools over again? If so, any suggestions
would be appreciated.

Frederick Faller

__________________________________________________
Do You Yahoo!?
Check out Yahoo! Shopping and Yahoo! Auctions for all of
your unique holiday gifts! Buy at http://shopping.yahoo.com 
or bid at http://auctions.yahoo.com 
_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge 
theforge mail list group photo site is
http://albums.photopoint.com/j/AlbumList?u=1169182 
___________