[Test-Equipment] Who makes this SMA Thumb Wheel?

[KA4INM]

   On 01/05/2015 08:24 PM, Brooke Clarke wrote:

> The DAGR GPS receiver has the SMA antenna jack (J3) in a hole and so
> needs a special SMA thumb wheel that reaches into the hole.
> I'm trying to find out who makes that plastic SMA thumb wheel. An
> example is on the DAGR to RA-1 antenna cable:

   The correct tool is:

 
http://www.amazon.com/SMA-16-Torque-Wrench-Coax/dp/B001OVN6QO/ref=sr_1_1?ie=UTF8&qid=1420668844&sr=8-1&keywords=sma+wrench

   I regret that they are so expensive.

   The alternative is to install an extension made of "hard line" that 
"brings out" the female to where a open end wrench will do.

(I always used a 5/16" ignition wrench.)
-- 
   Ron  KA4INM - Youvan's corollary:
                 Every action results in unwanted side effects.