[Test-Equipment] need old style mic connectors

[hwhall at compuserve.com]

I've seen some of those at my local surplus store, OEM Parts, for $5.95 each, if I recall correctly. 
 

 Wayne
WB4OGM

 

-----Original Message-----
From: Ron Bussiere via Test-Equipment <test-equipment at mailman.qth.net>
To: test-equipment <test-equipment at mailman.qth.net>
Sent: Fri, May 16, 2014 2:26 pm
Subject: [Test-Equipment] need old style mic connectors


Hi. I restore a lot of 'vintage' test equipment, just for fun, (not to resell, 
but I probably should)!!

Old VTVMs and other stuff use the old, single pin mic style connector. I almost 
always change them over to BNC females, since the panel hole is the same size, 
and that is what all my test leads are, etc.

I need a small quantity of these older mic connectors. I'll be darn if I can 
find them, for less than $25 EACH!!!!
My Sweep Generators use 4 of these connectors to output to the scope, etc, but 
use a BNC for the RF output. Should I just change them all to BNCs and be done 
with it????
I would have 'thought' these old single pin connectors would be everywhere AND 
cheap......

thanks
ron
N4UE
______________________________________________________________
Test-Equipment mailing list
Home: http://mailman.qth.net/mailman/listinfo/test-equipment
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Test-Equipment at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html